At 25.1mV/Pa, the mic’s sensitivity is higher than many competitive models. sE Electronics X1R bei bonedo im Test – Bändchenmikrofone stellen den beliebtesten Sonderweg zwischen Kondensator- und Tauchspulenmikrofon dar. The sEX1R does not offer the full frequency response performance of the Voodoo VR1 / VR2 and the widely acclaimed sE Rupert Neve RNR1, but a hybrid of old and new ribbon technology which gives you all the natural beauty of the ribbon sound, but with more versatility and ease of use than the majority of ribbons on today's market. The microphone gives a warm tone to vocals, but the hf roll off would make it difficult for them to really stand out in a complex mix. As it is a ribbon mic, a pop shield would certainly be required as the plosive consonants like ‘b’s and ‘p’s will make the capsule pop quite easily. It may seem strange to completely redesign the mechanics and electronics of a microphone and then house it in an old body, but there is a good reason for that. ". Deviations in different severities at different frequency bands have an effect on the sound character. SE Electronics X1R Isolation Bundle SE Electronics X1R + SE Electronics Isolation Pack . SE Electronics X1 Series Ribbon Microphone and Clip The X1 R is a rugged ribbon for any purpose. Electric guitar The frequency response of ribbon microphones usually tails off in the higher frequencies, which means they sound soft, warm and unobtrusive. Frequency response: 20-16000 Hz / - 1 dB; Sensitivity: -55.3 dB 1V / Pa / - dB; Directional characteristics: Figure Eight; Impedance: 200 Ohm; Connection: 3-pin; Max SPL: 135 dB; Incl. Unter diesen Vorteilen ist der besondere Klangcharakter der Ribbons, weshalb sie gerne für … © 2020 sE Electronics International, Inc.All Rights Reserved. Frequency response (tonal balance) is the most sound-determining aspect of headphones. The X1R has the warmth of much older ribbon or tube mics with the modern twist of an hf extension, which gives it a lot of character and will certainly bring something new and useful to your mic collection. This is especially useful if you want to use it with condenser mics on one interface, but you can’t set phantom power on individual channels. The X1 R doesn't quite offer the full-frequency response performance of the VR1, VR2, or the widely acclaimed Rupert Neve Signature Series RNR1 - but its hybrid old and new ribbon technology gives you all the natural beauty of the ribbon sound, but with more versatility and ease of use than the majority of ribbons on today's market. The X1r has a max SPL of 135dB, which is a lot. In fact, it’s enough to rig in front of a guitar cab – which of course we did. A horizontal line shows audible neutral response in the plots on this website. shockmount included: No: Bundle Offer 1. This was mostly a test to see if the mic could stand up to the high SPLs from a guitar cabinet (which it did), but the sound it produced was a welcome surprise. Recording Acoustic Guitar: Advanced Techniques M/S Pair, Active Speakers For Home Recording And Mixing. The frequency response of ribbon microphones usually tails off in the higher frequencies, which means they sound soft, warm and unobtrusive. The sEX1R does not offer the full frequency response performance of the Voodoo VR1 / VR2 and the widely acclaimed sE Rupert Neve RNR1, but a hybrid of old and new ribbon technology which gives you all the natural beauty of the ribbon sound, but with more versatility and ease of use than the majority of ribbons on today's market. The sEX1R does not offer the full frequency response performance of the Voodoo VR1 / VR2 and the widely acclaimed sE Rupert Neve RNR1, but a hybrid of old and new ribbon technology which gives you all the natural beauty of the ribbon sound, but with more versatility and ease of use than the majority of ribbons on today's market. Having said that, it might work very well on something simple and open like a solo vocalist with an acoustic guitar, or for spoken word. The two-micron-thick aluminium ribbon can handle SPLs up to 135dB, so this is no fragile flower, while the frequency response is within ±1dB from 20Hz to 16kHz. This is true of the X1r which has the natural tone of a ribbon mic, but has also inherited some of the HF extension technology from its bigger brothers the V1 and V2 which gives it a gentle boost around 5kHz. The microphone’s element is enclosed by Neodymium magnets and is housed is a chassis whose design is based on sE’s X1 cardioid microphone. The mic’s frequency response is nominally flat from 30Hz–3kHz, and has a smoothly rising presence peak (+3dB) around 12kHz. The second addition to the X1 Series, the X1 R brings the magic of traditional ribbon mics into the modern age with a tough construction that can handle any SPL. By pricing it at £299, sE have made the X1R a strong contender for those looking to buy a high-quality microphone for home recording, which is exactly where we feel it fits.